Changing Fc-200 Settings From The Ср-100 - Roland GP-100 Owner's Manual

Section 5 Appendix
Changing FC-200 Settings from the
GP-100
Here's how you can modify FC-200 settings by operating the GP-
100. The settings are transmitted via MIDI to the FC-200. Connec-
tions and procedure are the same as explained in "Bank Limit
Settings" (p. 58).
* Make sure that the GP-100 and the FC-200 are both set to the same
MIDI channel. With the factory settings, the MIDI channel is set to
channel 1.
1 Press ihe [UTILITY] button several times until the parameter
you wish to set appears in the display. Each time you press the
button you will cycle through the following items.
«Function Settings»
«MIDI-Related Settings»
«Harmonist Settings»
«FC-200 Settings»
Feza CTL Pedal
Hamentard
Make settings for the FC-200 MIDI foot controller (op-
tional) from the GP-100 via MIDI.
2 Rotate the PARAMETER knob until the parameter you wish to
set appears in the display.
З Use the VALUE knob to modify the value.
4 Repeat steps 2—3 to make FC-200 settings.
5 Rotate the PARAMETER knob until the following parameter
appears in the display.
FCzBüB8 Data Send
I
a5
Push [WEITE]
6 Press the [WRITE] button, and the data will be transmitted.
* At this time, data will be transmitted to set the FC-200 in a state
(Bank Select: On) where it will be able to transmit Bank Select
messages. If the FC-200 is connected for use to a device other than
the GP-100, operate the FC-200 to set its Bank Select setting to
"Off. L4
7 Press the [EXIT] button to end the procedure.
When the procedure is completed, restore the MIDI cable
connections to the previous state.
62
«FC-200 parameters that are set»
Control pedal operation mode: Momentary, Latch
CTL Pedal
Momentary
This sets the way in which the FC-200 control pedal will operate.
Momentary: Thepedal will function as amomentary-type switch;
"On" (maximum value) when the pedal is pressed,
and "Off" (minimum value) when the pedal is
released.
Latch: The pedal will function as a latch-type switch;
alternating between "On" (maximum value) and
"Off" (minimum value) each time the pedal is
pressed.
Bank Limit settings: 0—39
FC28H8 Bank Limit
Bank = 39
When the FC-200 is in Program Change mode, the Bank pedal
specifies the Bank. This setting specifies the upper limitofthe Bank.
Program Number change when selecting a Bank:
Number, Bank
FC28B FC Dut
Humber
When the FC-200 is in Program Change mode, this parameter
specifies whether the GP-100 Patch will change when the Bank is
selected, or when the Number is selected.
* This parameter corresponds to the FC-200's "Bank Output" setting.
Number: The GP-100 Patch will not change when you change
the Bank. It will change when you use the number
pedals to specify the Number.
Bank: The GP-100 Patch will change when you change the
Bank. The number of the last-selected number pedal
will be used.