Hands Editing (Using The Fc-200 To Create Sounds) - Roland GP-100 Owner's Manual

Section 5 Appendix
Using the FOOT SW/EXP Jack
When a separately available foot switch or expression pedal is
connected to an FC-200 FOOT SW/EXP Jack, pedal or switch
movements will transmit Control Change messages of the control-
ler number specified for each jack.
The GP-100 can receive these Control Change messages as one of
the "control assign sources" specified in each Patch, and control
the specified target parameters.
The controller numbers specified for each FC-200 jack are as
follows,
* These can be used when the FC-200 is in "Program Change mode,"
"Control Change mode," or "Note mode."
The type and timing of the messages transmitted by the FOOT SW/
EXP Jack will depend on the type of device that is connected. Use
the type of foot switch or pedal that is appropriate for your needs.
When an FS-5L (BOSS) foot switch is connected
When you press the switch, an "On" (maximum value) message
will be transmitted. When you press the switch once again, an
"Off" (minimum value) message will be transmitted. The pedal
indicator will light when the pedal is on.
When an FS-5U (BOSS) foot switch is connected
When you press the switch an "On" (maximum value) message
will be transmitted, and when you release the switch an "Off"
(minimum value) message will be transmitted.
When an EV-5 expression pedal is connected
When you move the expression pedal, messages will be transmit-
ted to continuously indicate the current position of the pedal, from
minimum to maximum values.
No-Hands Editing
(Using the FC-200 to Create Sounds)
You can operate the FC-200 to edit GP-100 sounds. Since this is
done by pedal operations, you can even modify GP-100 settings
while you continue playing.
Start the procedure in the following condition.
FC-200: Exclusive mode
* Make sure that the GP-100 and the FC-200 are both set to the same
MIDI channel. With the factory settings, the MIDI channel is set to
channel 1,
The functions ofeach button and knob on the GP-100's front panel
are assigned to the foot switches and expression pedal of the FC-
200 as follows. You can use the FC-200 to perform the same
operations as you can from the GP-100's front panel.
PREAMP GLOBAL TUNER UTILITY METER EFFECT
LALA ИМЯ
E ANH
уз / Mal Fe ld —
|
LI [||
LU
M
H H 1 = M
WRITE EXIT v A v A VALUE
PARAMETER NUMBER/
VALUE
61