Safety And Emc Instructions; Transportation And Storage; Preparation; Installation - PROLiNK Professional II+ Series User Manual

1. SAFETY AND EMC INSTRUCTIONS

Please carefully read the following user instructions and safety instructions before installing the unit or
using the unit!

1-1. Transportation and Storage

Please transport UPS systems use only the original pakaging to protect against shocks and
impacts.
UPS should be stored in a ventilated and dry room.

1-2. Preparation

Condensation can occur if the UPS system is moved directly from a cold to warm environment.
The UPS system must be completely dry before installation. Please allow at least two hours for the UPS
to get used to its environment.
Do not install UPS systems near water or in humid environments.
Do not install a UPS system where it will be exposed to the sun directly or near the heater.
Do not cover the ventilation holes on the UPS.

1-3. Installation

Do not connect equipment or devices that would overload the UPS system *e.g. laser printer) to
the output of the UPS socket.
Place the cable in such a way that no one can step on it or trip.
Do not block the air vents on the UPS. The UPS should be placed in a location with ventilation
which is good. Make sure there is enough space for ventilation on each side.
UPS has provided a Grounding terminal, at the last installation, connect the UPS grounding to
the UPS battery external cabinet.
UPS should only be installed by expert and qualified personnel.
A suitable switch brake for short-circuit protection must
provided in building cabling installations.
An integrated emergency switch single switch will prevent further supply to the load by the UPS;
in some cases this must be provided in the cabling installation of the building.
Connect the grounding before connecting to the wiring terminals of the building.
Installation and Wiring shall be carried out in accordance with electrical laws and regulations
Local.
1