Table of Contents
Advertisement
Subfeeder
Arc verification
Weld data duration
Safe wire inch
(MIG only)
Gas guard (Master M 355 only)
Voltage display
Language
PIN code
Device info
Factory reset
3.3.8 Control panel: Weld data
After each weld, a weld summary is displayed briefly. To change the weld data view duration, refer to "Control panel: Sys-
tem settings" on page 43.
© Kemppi
Subfeeder model / OFF
Default = OFF
1...365
Default = 0 (OFF)
0...10 s, step 1
Default = 5 s
OFF/ON
Default = ON
ON/OFF
Default = OFF
Arc voltage / Terminal voltage
Default = Arc voltage
Available languages
ON/OFF
Reset/Cancel
Default = Cancel
45
Operating manual - EN
If a compatible subfeeder is connected,
select the subfeeder from the list.
Compatible subfeeders:
SuperSnake GTX 10 m, 15 m, 20 m, 25 m,
Binzel PP401D, Binzel PP36D.
Note: For the best possible welding result
when using the pulse and MAX welding
processes with a subfeeder device, we
recommend a maximum subfeeder cable
length of 10 meters (SuperSnake GTX 10
m). This recommendation assumes that
you are using a 5-meter welding gun
cable and a 15-meter earth return cable
together with the subfeeder. In some
cases, it is possible to weld with pulse
and MAX welding processes with a 15-
meter subfeeder device, but a test weld is
advised.
This defines the number of days to the
next device verification.
This defines how long the weld data sum-
mary is shown after each weld.
When ON, and the arc doesn't ignite, the
filler wire is fed 5 cm. When OFF, 5 m of
filler wire is fed.
Gas guard prevents welding without
shielding gas.
This defines which is shown on the con-
trol panel display, arc or terminal voltage.
4-digit PIN code for locking the control
panel after 30 s of inactivity. PIN lock does
not prevent welding, browsing Powerlog
levels or selecting memory channel.
Shows information on the device and its
usage.
Restores factory settings. Note that the
arc verification parameter value is also
reset.
Master M 353, 355
1921960 / 2307
Advertisement
Table of Contents
