Kemppi Master M 353 Operating Manual page 44

Changing settings
1. Turn the right control knob to highlight the desired settings parameter.
2. Press the right control knob to select the settings parameter for adjustment.
3. Turn the right control knob to select the settings value.
>> Depending on the settings parameter to be adjusted, refer also to the Settings table below for more details.
4. Confirm the new value / selection by pressing the right control knob.
Settings
Parameter
Remote
Remote selection
Remote mode
Remote min.
Remote max.
Cable calibration
(MIG only)
Water cooler
Cycle timer
- Cycle timer time
WF end step
© Kemppi
Parameter value
ON/OFF
Default = OFF
Hand remote / Gun remote
Default = Hand remote
Wire feed speed / Channel
Default = Wire feed speed
Defined by the active welding program
Defined by the active welding program
Start/Cancel
OFF/Auto/ON
Default = Auto
ON/OFF
Default = OFF
0.0 ... 60.0 s
Default = 2.0 s
OFF/ON
Default = OFF
44
Operating manual - EN
Description
Select whether remote is used.
This determines what is changed with
the remote, wire feed speed or memory
channel (available channels: 1...5).
Minimum and maximum limits for the
remote wire feed speed adjustment.
Calibration information on the previous
calibration is also shown. Refer to "Cal-
ibrating welding cable" on page 34 for
cable calibration.
When ON is selected, the coolant is cir-
culated continually, and when Auto is
selected, the coolant is circulated only
during welding.
A welding function that automatically
produces a weld of a predefined dur-
ation.
Wire feed end step feature prevents the
filler wire from sticking to the contact tip
when the welding ends.
Master M 353, 355
1921960 / 2307