Step 5. Mount Powerwall On The Bracket - Tesla Powerwall 2 AC Installation Manual

Step 5. Mount Powerwall on the Bracket

1. Move the lift equipment close to the wall and remove the tie-down strap securing the
Powerwall to the lift equipment.
2. Adjust the height of the Powerwall so that its mounting cleats are just above the flanges on
the bracket. (If the bracket and cleat locations are marked with tape, use those marks to
gauge the height.)
3. Begin to lower the Powerwall so that the top cleat engages the top flange on the bracket.
Ensure that the bottom cleat aligns with the bottom flange of the bracket.
4. With both cleats engaged, lower the Powerwall onto the bracket. When the cleats are
seated in the bracket, the locking mechanism at the center of the top flange should click into
place.
NOTE: To remove Powerwall from the mounting bracket, place a thin piece of sheet metal
between the Powerwall unit and the bracket to compress the locking mechanism, and lift the
Powerwall straight up.
Figure 22: Mounting Powerwall on the Bracket
23