Step 3. Anchor The Powerwall Mounting Bracket - Tesla Powerwall 2 AC Installation Manual

11. Grasp the top of the Powerwall and carefully tilt it upright until it sits vertically in the box,
with the front of the unit facing the lift equipment.
Figure 7: Removing Powerwall from Its Box
12. Position the Powerwall on the lift equipment, with the mounting cleats facing away from
the lift equipment.
13. Strap the Powerwall to the lift equipment with a ratcheting tie-down strap.

Step 3. Anchor the Powerwall Mounting Bracket

1. Before mounting the wall bracket, double-check that the mounting location will allow access
to the chosen cable entry port (side or back) during installation. If applicable, use a stud
sensor to locate and mark the centers of the studs in the wall.
2. Determine the appropriate type and number of fasteners for the mounting bracket location.
Be sure to take into account the thickness of the mounting bracket, washers, and wall material
when choosing fasteners. The following guidelines apply to both wall- and floor-mount
installations.
NOTE: The details below are minimum guidelines and are not guaranteed to be applicable.
Refer to local building codes to ensure the use of appropriate fasteners. Refer to Powerwall 2
Anchorage Details for complete mounting information.
14 Powerwall Installation Manual