Powerwall Installation Requirements; Backup Gateway Installation Requirements - Tesla Powerwall 2 AC Installation Manual

Powerwall Installation Requirements

Powerwall comes with a separate Backup Gateway and power meter to enable integration
with solar systems and the electrical grid. The Backup Gateway communicates with the
system by means of wireless and wired connections. Wiring and conduit (where required)
must be provided by the installer. Where conduit is required, the installation must comply with
local codes.
AC disconnect and interconnection requirements between the Powerwall system and the main
switchboard are subject to local codes. Ensure that the installation meets local disconnect and
interconnection requirements.
When Powerwall is installed in a dwelling unit, fire detection and protection equipment should
be installed in accordance with local building and fire codes.
All installations must conform to the laws, regulations, codes, and standards applicable in the
jurisdiction of installation.

Backup Gateway Installation Requirements

The Backup Gateway must be wall-mounted and can be configured for cable entry at the top,
bottom, or sides of the enclosure. It requires adequate clearance for installation and cabling or
conduit. Wiring and conduit (where required) must be provided by the installer. Where
conduit is required, the installation must comply with local codes.
Mount the Backup Gateway vertically, in the orientation shown below (Fig. 3). Do not mount
the Backup Gateway enclosure horizontally or upside down.
All installations must conform to the laws, regulations, codes, and standards applicable in the
jurisdiction of installation.
Figure 3: Backup Gateway Dimensions
9