Printing Of Paging Seal - Pantum CP2100 Series User Manual

7.2.5. Printing of paging seal

Printing of documents with paging seal is supported. When the printed portrait of paging seal does
not meet the requirements, you can adjust the margins and offset values of the printed portrait in the
following steps. The operation steps are as follows:
1. Press the printer Control Panel " " to enter the ready interface.
2. Press "▲" or "▼" to select "Print Settings"-"Margin Settings" to adjust the offset values of the left
margin and the top margin.
3. Print the portrait again after the adjustment is completed. If the portrait still does not meet the
requirements, repeat Step 1 and 2 until the portrait is normal.
• The offset value ranges from -5 mm to 5 mm and is adjusted at the rate of ±0.5 mm.
Note:
70