How To Disable The Wi-Fi Network Connected; Wi-Fi Direct Mode; Preliminary Preparations; Wi-Fi Direct Connection - Pantum CP2100 Series User Manual

5.1.2.1. Preliminary preparations

1. The access point (wireless router) supports Wi-Fi Protected Setup (WPS).
2. A printer that has wireless network function.
5.1.2.2. Wi-Fi Protected Setup (WPS) method
1. Turn on the power of printer and access point (wireless router).
2. Make sure the printer is in ready state.
• If the printer is in sleep mode, it can be woken up by pressing any key on the control
Note:
panel of printer.
3. Press "Wi-Fi" button on the printer panel for over 2s until the Wi-Fi indicator flashes in blue and
then release the button.
4. Press the WPS key on access point (wireless router) within 2min and then release it.
5. When the access point (wireless router) and printer start to connect, the blue Wi-Fi indicator of
printer starts to blink. The blue Wi-Fi indicator of printer will be normally on after successful
connection.
If the connection is not established after more than 2min, the printer will return to its ready state, the
Wi-Fi indicator will be off and Wi-Fi Protected Setup (WPS) connection will fail. If it is needed to
connect again, please repeat steps 3-4 above.
• Please refer to
Note:
• After successful Wi-Fi Protected Setup (WPS) connection, please install a driver if you
want to print via wireless network.

5.1.3. How to disable the Wi-Fi network connected

Connect the wireless network in infrastructure mode by the steps above. If connected, the Wi-Fi
light on the control panel is normally on. Press and hold this button for more than 2s to disconnect
from Wi-Fi network (Wi-Fi light will be off).

5.2. Wi-Fi Direct mode

You can connect wireless client (including the computer and mobile device with wireless network
feature) to wireless network printer without using the access point (wireless router).
5.2.1. Preliminary preparations
1. Printer with the Wi-Fi Direct feature.
2. Wireless client (including computer and mobile device with wireless network feature).

5.2.2. Wi-Fi Direct connection

Before connecting to printer hotspot, turn on direct Wi-Fi connection of the printer by short pressing
"Wi-Fi" button on the panel.
• Short press "Wi-Fi" button on the printer panel to automatically print out "Mobile Device
Note:
Wi-Fi Connection Wizard" page for Wi-Fi connection by mobile devices.
Chapter 5.1.3 for how to cancel and disconnect Wi-Fi connection.
53