Emc Notice - Barco Nio MDNC-3521 SNES User Manual

turning the device off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the device and receiver.
• Connect the device into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
FCC responsible: Barco Inc., 3059 Premiere Parkway Suite 400, 30097 Duluth GA, United States, Tel: +1
678 475 8000
Canadian notice
CAN ICES-001(B) / NMB-001(B)
Brazilian local representative
Barco Ltda, Av. Ibirapuera, 2332 - Andar 8 - Bloco 2 - Conj 82, Bairro:Ibirapuera, Distrito:Moema, 4028-002,
São Paulo, Brasil

7.5 EMC notice

General information
This device is for use in professional healthcare facility environments only.
With the installation of the device, use only the delivered external cables and power supply or a spare part
provided by the legal manufacturer. Using another can result in a decrease of the immunity level of the device.
WARNING: Use of this equipment adjacent to or stacked with other equipment should be avoided
because it could result in improper operation. If such use is necessary, this equipment and the other
equipment should be observed to verify that they are operating normally.
WARNING: Use of accessories, transducers and cables other than those specified or provided by
the manufacturer of this equipment could result in increased electromagnetic emissions or
decreased electromagnetic immunity of this equipment and result in improper operation.
WARNING: Portable RF communications equipment (including peripherals such as antenna cables
and external antennas) should be used no closer than 30 cm (12 inches) to any part of the Nio 2MP /
3MP LED Display, including cables specified by the manufacturer. Otherwise, degradation of the
performance of this equipment could result.
Electromagnetic emissions
The Nio 2MP / 3MP LED Display is intended for use in the electromagnetic environment specified below. The
customer or the user of the Nio 2MP / 3MP LED Display should assure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Compliance
Group 1
Class B
Class D
R5915130 /05
Important information
Electromagnetic environment –
Guidance
The Nio 2MP / 3MP LED Display
uses RF energy only for its internal
function. Therefore, its RF
emissions are very low and are not
likely to cause any interference in
nearby electronic equipment.
The Nio 2MP / 3MP LED Display is
suitable for use in all
establishments, including domestic
establishments and those directly
Nio 2MP / 3MP LED Display 51