Barco Nio MDNC-3521 SNES User Manual page 13

Install the display controller
Before you connect your display with the workstation, make sure to have a suitable
in the workstation.
The Nio 2MP / 3MP LED Display operates at its full specifications when driven by a Barco MXRT
display controller and MXRT driver (which also includes the Barco Intuitive Workflow Tools). If
you ordered a MXRT display controller, it is included in the box of your display.
For more information and installation instructions, please check the Barco "Display Controller and
Intuitive Workflow Tools" user guide on the included documentation CD, or at
support.
Connect the cables
1. Remove the connector cover.
2. Connect one of the DisplayPort inputs (DP IN 1 or DP IN 2) with the DisplayPort output on the workstation.
3. Connect the main USB upstream connectors (USB UP 1) with a USB host on the workstation to make use
of QAWeb Enterprise or a peripheral (keyboard, mouse, touchpad, etc.) connected to one of the display's
USB downstream connectors.
4. Connect a keyboard and mouse (or another peripheral used to control the workstations) with the USB
downstream connectors of the display. Three USB downstream connectors are available in the connector
compartment.
Note: When DPMS mode with USB charging is enabled (see
hibernate is enabled (see
hibernate with a mouse/keyboard connected to the display.
When DPMS mode without USB charging is enabled (see
is enabled (see
pressing the jog dial, or with a mouse/keyboard connected to the workstation (and not to the
display).
5. Connect the supplied external DC power supply to the power input on the display.
6. Route all cables through the cable clips in the connector compartment.
7. Re-install the connector cover: slide the top of the cover in the available recesses, then push the bottom of
the cover back into position.
8. Route all cables through the routing channels in the stand of your display.
9. Connect the external DC power supply to a grounded power outlet by using one of the power cables
included with the display.
2. For a list of compatible display controllers, please refer to the compatibility matrix available on my.barco.com (MyBarco > My Support
> Healthcare > Compatibility Matrices > Barco Systems Compatibility Matrices)
"Hibernate", page
"Hibernate", page 28), you can only awaken your system from hibernate by
"DPMS mode", page
28), you can easily awaken your system from
"DPMS mode", page
R5915130 /05 Nio 2MP / 3MP LED Display
Installation and setup
2 display controller installed
www.barco.com/
27) and
27) and hibernate
13