Table of Contents
Advertisement
3.
Enter the Presence Sensor(PS) submenu.
4.
Select Enabled/Disabled as desired and confirm.
To adjust the presence sensor timer
1.
Bring up the OSD main menu.
2.
Navigate to the Power Management menu.
3.
Enter the PS Timer submenu.
4.
Set the presence sensor timer value as desired and confirm.
4.9 Dry mode
About dry mode
Dry mode prevents condensation from forming in the display. When the display enters power saving mode
(hibernate), the backlight will remain powered at a minimum level to maintain some heat in the panel when dry
mode is enabled.
DPMS mode must be enabled before dry mode can be enabled. See
Dry mode is available on MDNC-2521 SPES and MDNC-3521 SPES versions only.
To enable/disable dry mode on your display:
1.
Bring up the OSD main menu.
2.
Navigate to the Power Management menu.
3.
Enter the Dry Mode submenu.
4.
Select Enabled/Disabled as desired and confirm.
4.10 Luminance target
About luminance target
The luminance target of your Nio 2MP / 3MP LED Display is adjustable over a predefined range. When you
change the luminance target, the display will adjust its backlight to reach the target.
To set the luminance target
1.
Bring up the OSD main menu.
2.
Navigate to the Image Settings menu.
3.
Enter the Luminance Target submenu.
4.
Set the luminance target value as desired and confirm.
The default, factory calibrated luminance value is available in the technical specifications table. The
guaranteed backlight lifetime is valid for this setting.
Advanced operation
"DPMS mode", page
R5915130 /05
Nio 2MP / 3MP LED Display
27.
29
Advertisement
Table of Contents
