Table of Contents
Advertisement
•
"KVM input switching", page 23
•
"OSD menu access and use", page 24
Image 3–1
To activate a shortcut bar function
1. During normal operation, press or turn the jog dial. The shortcut bar is activated.
2. Turn the jog dial left or right to select a function.
3. Press the jog dial to confirm your selection and to activate the function.
3.3 On/Off switching
To switch on your display
Press/Turn the jog dial to activate your display.
To switch off your display
1. Press/Turn the jog dial to activate the shortcut bar.
2. Turn the jog dial and select the standby icon (
3. Press the jog dial to confirm your selection.
4. Press the jog dial again to switch off the display.
3.4 KVM input switching
About the KVM switch
The Nio 2MP / 3MP LED Display can be used in dual workstation setup with KVM switch. This allows the
display to be connected to two different workstations and control both with a single keyboard and mouse
connected to the display. Switching the video and control signals between the two workstations is done with
the KVM switch operated via the OSD menu.
Your display system must be specifically set up and configured for KVM input switching. For
instructions, see
To switch KVM inputs
1. Press or turn the jog dial to activate the shortcut bar. The KVM switch icon (
when the KVM switch is enabled.
2. Press the jog dial again to switch KVM inputs.
During normal operation, double-press the jogdial to switch KVM inputs more quickly. A first click will
make the shortcut bar pop up, a second click will switch inputs (since the KVM switch icon is
selected by default when the KVM switch is enabled).
When switching KVM inputs, the video is switched instantly while switching the USB signal might
take a little longer (up to 2 seconds).
"Dual workstation setup with KVM switch", page
).
14.
R5915130 /05
Nio 2MP / 3MP LED Display
Daily operation
) is selected by default
23
Advertisement
Table of Contents
