Key Indicator Lights; Power Lock Function; Dpms Mode - Barco MDCC-4330 User Manual

Hide thumbs Also See for MDCC-4330:
Table of Contents

Advertisement

4.
Select Enabled/Disabled as desired and confirm.

4.4 Key indicator lights

About the key indicator lights
By default, after lighting up, the key indicator lights will dim again if no further actions are taken within the
following 5 seconds. However, this behavior can be changed so that the key indicator lights are always on or
always off.
To configure the key indicator lights
1.
Bring up the OSD main menu.
2.
Navigate to the Configuration > User Interface > Indicator Lights menu.
3.
Enter the Keys submenu.
4.
Select Automatic/Always On/Always Off as desired and confirm.

4.5 Power lock function

About the power lock function
By enabling the power lock function, the Coronis Fusion 4MP / 6MP is forced to remain switched on. This
means that it can't be switched to stand-by mode manually until the power lock function is disabled again.
To enable/disable the power lock function:
1.
Bring up the OSD main menu.
2.
Navigate to the Configuration > User Interface > Controls menu.
3.
Enter the Power Lock submenu.
4.
Select Enabled/Disabled as desired and confirm.

4.6 DPMS mode

About DPMS mode
Enabling the Display Power Management System (DPMS) mode on your display will optimize its diagnostic
lifetime by automatically switching off the backlight when the display is not used for a specified period of time.
By default, DPMS mode is enabled on your display, but it also needs to be activated on your workstation. To
do this, go to the "Power options properties" window of your workstation.
Barco recommends setting DPMS activation after 20 minutes of non-usage.
When DPMS mode is enabled on your display, an additional OSD power saving function becomes
available: hibernate. Please refer to "Hibernate", page 26 for more information on hibernation and
how to enable this function.
To enable/disable DPMS mode on your display:
1.
Bring up the OSD main menu.
2.
Navigate to the Configuration > Power Management menu.
3.
Enter the DPMS Mode submenu.
4.
Select Enabled/Disabled as desired and confirm.
Advanced operation
K5902108 /06
Coronis Fusion 4MP / 6MP
25

Advertisement

Table of Contents
loading

This manual is also suitable for:

Coronis fusion 6mpCoronis fusion 4mpMdcc-6430

Table of Contents