Table of Contents
Advertisement
4. Daily operation
4.2
Keyboard backlight
About the keyboard backlight
By default only the stand-by key is visible. After keyboard activation (see "OSD menu activation", page
25), the backlight of all keys is switched on for a few seconds. When you touch any of these keys again
while the backlight is on, the function of the key is executed. If no further action is taken within the time-out,
the keyboard backlight is switched off again.
The keyboard backlight auto-dim function can be disabled in the OSD menu so that the
keyboard backlight is always on (Keyboard Backlight).
4.3
On/Off switching
To switch on your display:
1. Activate the power supply through the switch located on the external power supply.
2. While your display is off, press and hold the stand-by key
keyboard backlight stops blinking).
To minimize the power consumption, also the external power supply has to be switched
off.
To switch off your display:
1. While your display is switched on, unlock the keyboard see "OSD menu activation", page 25.
2. Press and hold the stand-by key
blinking and switches off).
While pressing the stand-by key to switch off the display, the front key illumination will
blink.
4.4
Power led status
About the the power led status
The behavior of the power led shows the status of the unit:
•
No led visible: the status of the unit is hard OFF (the switch of the power supply is OFF)
•
Led is fading between on and off: the status of the unit is soft OFF (when pushing the standby button,
the unit is on or off)
•
Led is full orange: the unit is in power save mode (no signal & power save mode enabled)
•
Led is blinking green/orange: the unit is in searching mode (looking for a signal)
•
Led is full green: the unit has an image on the screen.
24
for approximately 3 seconds (or until the keyboard backlight stops
K5902135 (451920612561) MDSC-2326 28/02/2017
for approximately 3 seconds (or until the
Advertisement
Table of Contents
