Fig. 36 Disassembly Handle; Fig. 37 Disassembly Toolboard - Beckhoff CP37 1600 Series Manual

Decommissioning
Fig. 36: Disassembly handle
To remove a toolboard from the device, follow the steps shown in Figure 37. During disassembly, ensure
that the individual components are secured against falling:
1. Loosen the two M4 screws of the strain relief housing (section A).
2. Loosen the four M5 screws on the toolboard (section B).
3. Loosen the three M5 screws of the toolboard bracket (section C).
ð You have dismantled the toolboard.
A
Fig. 37: Disassembly toolboard
Removing the mounting arm adapter
If you have installed one of the two available Beckhoff mounting arm adapters on your panel PC, follow the
steps below to remove it (see Fig. 38):
1. Remove the cover of the mounting arm adapter (section A). For the exact procedure, see chapter 3.2
Interface description [} 12].
2. Loosen the four M6 screws securing the mounting arm adapter to the panel PC (section B).
3. Remove the mounting arm adapter from the panel housing.
44
B
Version: 1.9
C
CP37xx-1600