Disassembly And Disposal; Fig. 22 Cp27Xx_Removal From The Control Cabinet; Fig. 23 Cp27Xx_Removal Installation Cutout - Beckhoff CP2712 Manual

6.2

Disassembly and disposal

In order to be able to dismount the panel PC from the control cabinet, you must first have disconnected the
power supply and the cables (see Chapter 5.1 Disconnecting the power supply and cables [} 36]).
To remove the panel PC from the control cabinet, follow the steps shown in Fig. 22 and 23:
1. Loosen the clamping levers with a 3.0 mm Allen key (sections A and B). Make sure that the device is
secured against falling out of the control cabinet wall.
2. Fold the clamping levers back onto the housing by 90° (section C) and tighten them there again so that
they do not fold out unintentionally.
A
Fig. 22: CP27xx_removal from the control cabinet
ð You can now remove the panel PC from the corresponding cutout in the control cabinet wall.
Fig. 23: CP27xx_removal installation cutout
Disposal of the panel PC
When disposing of the panel PC, be sure to observe the national electronic waste regulations.
For disposal, you must remove the device from the control cabinet.
CP27xx
B
Version: 2.0
Decommissioning
C
37