Installing A Toolboard And Handle; Fig. 28 Installing Handle; Table 21 Mechanical Extensions - Beckhoff CP37 1600 Series Manual

4.2.3

Installing a toolboard and handle

You have the option to mechanically extend your device. The following ordering options are available: Follow
the links provided to get to the respective product pages with images of the ordering options:
Table 21: Mechanical extensions
Order identifier
C9900-M361
C9900-M419
The ordered extensions are delivered with the device, you must install them yourself afterwards. Install the
handle to the bottom of the device using the two M5 screws (see fig. 28).
Fig. 28: Installing handle
To mount a toolboard on the device, follow the steps below, which are shown in figure 29:
1. Screw the toolboard brackets to the bottom of the device using the three M5 screws (section A).
2. Screw the toolboard to the underside of the bracket using the four M5 screws (section B).
3. Screw the two strain reliefs to the underside of the toolboard using the two M4 screws (section C).
ð You have mounted the toolboard on the device.
CP37xx-1600
Version
Handle, length = 386 mm, anodized aluminum
• ex factory on CP3x12 to CP3x24, mounted on the bottom of a control panel
or panel PC
• for retrofitting for CP3xxx-1600
http://www.beckhoff.com/c9900-m361
Toolboard for keyboard or tools
• ex factory on CP3x12 to CP3x24, mounted on the bottom of a control panel
or panel PC
• for retrofitting for CP3xxx-1600
http://www.beckhoff.com/c9900-m419
Version: 1.9
Commissioning
33