Disassembly And Disposal; Fig. 18 Removal From The Control Cabinet - Beckhoff CP6706-0001 Manual

Decommissioning
6.2

Disassembly and disposal

Before you can remove the device from the control cabinet front, you must first disconnect the power supply
and the cables (see chapter 6.1 Disconnecting the power supply and cables [} 29]).
To remove the device from the control cabinet front, follow the steps shown in Fig. 18:
1. Loosen the clamping levers with a 2.5 mm Allen key (section A). Make sure that the device is secured
against falling out of the control cabinet front.
2. Turn the clamping levers back by 90° onto the housing (section B).
ð You can now remove the device from the control cabinet front.
3. To reattach the clamping levers to the housing, retighten them with the Allen key (section C).
ð You have disassembled the device.
A
Fig. 18: Removal from the control cabinet
Disposal of the panel PC
When disposing of the device follow the national electronic scrap regulations.
30
B
Version: 2.0
C
CP6706-0001