Fig. 14 Orientation Of The Mounting Arm Adapter; Fig. 15 Installing The Mounting Arm Adapter - Beckhoff CP37 1600 Series Manual

Commissioning
Fig. 14: Orientation of the mounting arm adapter
To fasten the mounting arm adapter to the panel PC, follow the steps below, shown in Fig. 15:
1. Remove the cover of the mounting arm adapter (section A). For the exact procedure, see chapter 3.2
Interface description [} 12].
2. Place the mounting arm adapter with the four M6 screws in front of the four M6 threaded holes at the
rear side of the panel PC (section B).
A
Fig. 15: Installing the mounting arm adapter
3. Tighten the four M6 screws with a tightening torque of 6 Nm.
4. Replace the cover on the mounting arm adapter.
ð You have installed the mounting arm adapter on the panel PC.
26
B
Version: 1.9 CP37xx-1600