Commissioning; Transport And Storage - Beckhoff CP37 1600 Series Manual

4

Commissioning

In order to use the panel PC, you must first commission it. The first step is to transport the device to is
operating location and unpack it. This is followed by the installation of the device on the mounting arm, the
connection of the cables and the power supply and finally the switching on of the panel PC.
Operating the device
The device is operated via the touch screen.
Damage to the touch screen
Operating the touch screen with unsuitable objects may damage the touch screen.
• Operate the touch screen only with bare fingers or wearing suitable gloves.
• If you use gloves, make sure that no hard particles such as metal shavings, glass splinters or similar
adhere to the glove.
If you, as the user, require additional protection for the touch screen against dirt and scratching, for example
due to dirty hands, this can be achieved with a Beckhoff protective film. The film provides short-term
protection for a few days.
You can either order a Beckhoff protective film individually and fit it yourself retrospectively, or you can order
the film for fitting directly ex factory. Please refer to the price list for the available protective films according to
the display size of your device.
Proceed as follows to attach the protective film to the touch screen:
1. Ensure that the environment is as dust-free as possible.
2. Thoroughly clean the surface of the device to be fitted with the film and remove all grease residues.
3. Detach the film from the backing at the short edge and place it on the surface.
4. Gradually remove the film from the backing. At the same time, use a doctor blade or other object with a
soft rubber or felt edge to apply the film.
5. Brush away air bubbles towards the edge with a doctor blade or other object with a soft rubber or felt
edge.
ð The film is now fitted.
4.1

Transport and storage

The specified storage conditions must be observed (see chapter 9 Technical data [} 53]).
Despite the robust design of the unit, the components are sensitive to strong vibrations and impacts. During
transport the device must therefore be protected from mechanical stress. Appropriate packaging of the panel
PC, in particular the original packaging, can improve the vibration resistance during transport.
Hardware damage due to condensation
Unfavorable weather conditions during transport can cause damage to the device.
• Protect the device against moisture (condensation) during transport in cold weather or in case of
extreme temperature fluctuations.
• Do not put the device into operation until it has slowly adjusted to the room temperature.
• Should condensation occur, wait for about 12 hours before switching the device on.
Unpacking
Proceed as follows to unpack the device:
1. Check the packaging for transport damage.
2. Remove packaging.
CP37xx-1600
NOTICE
NOTICE
Version: 1.9
Commissioning
23