Maintenance And Care; Centering The Running Belt - Sunny Health & Fitness PEGASUS SF-T722054 User Manual

General cleaning will help prolong the life and performance of your treadmill. Keep the unit clean and
maintained by dusting the components on a regular basis. Clean both sides of the Running Belt (No.
17) to prevent dust from accumulating underneath the Running Belt (No. 17). Keep your running
shoes clean so that dirt from your shoes does not wear out the Running Board (No. 18) and
Running Belt (No. 17). Clean the surface of the Running Belt (No. 17) with a clean damp cloth.
To better maintain the treadmill and prolong its life it is suggested that the treadmill be powered off for
10 minutes every 2 hours and fully powered off whenever not in use.

CENTERING THE RUNNING BELT:

Place the treadmill on level ground and set it at 3-5 MPH to check if the Running Belt (No. 17) drifts.
If the Running Belt (No. 17) moves to
the right, turn the right adjustment bolt
¼ turn clockwise, then turn the left
adjustment bolt ¼ turn counter-
clockwise. If the Running Belt (No.
17) does not move, keep adjusting ¼
turn at a time until it centers. Refer to
Fig. 4.
If the Running Belt (No. 17) moves to
the left, turn left adjustment bolt ¼ turn
clockwise, then turn the right
adjustment bolt ¼ turn counter-
clockwise. If the Running Belt (No.
17) does not move, keep adjusting ¼
turn at a time until it centers. Refer to
Fig. 5.
Over time the Running Belt (No. 17)
will loosen. To tighten the Running
Belt (No. 17), turn the left and right
adjustment bolts one full turn
clockwise, check the tension of the
Running Belt (No. 17). Continue this
process until Running Belt (No. 17)
is at the correct tension. Make sure to
adjust both sides equally to ensure
correct Running Belt (No. 17)
alignment. Refer to Fig. 6.
MAINTENANCE & CARE
7
Fig. 4
Fig. 5
Fig. 6