Maintenance And Care; Centering The Running Belt - Sunny Health & Fitness SF-T7718 SMART User Manual

General cleaning will help prolong the life and performance of your treadmill. Keep the unit clean and
maintained by dusting the components on a regular basis. Clean both sides of the Running Belt (No.
C31) to prevent dust from accumulating underneath. Keep your running shoes clean so that dirt from
your shoes do not wear out the Running Board (No. D18) and Running Belt (No. C31). Clean the
surface of the Running Belt (No. C31) with a clean damp cloth. Keep liquids away from electrical
parts and Running Belt (No. C31).
To better maintain and prolong the life of the treadmill, it is recommended that the treadmill be
powered off for 10 minutes every 2 hours and fully powered off whenever not in use.

CENTERING THE RUNNING BELT:

Place the treadmill on level ground and set it at 3-5 MPH to check if the Running Belt (No. C31) drifts
from the center.
If the Running Belt
to the right, turn the right adjusting bolt ¼
turn clockwise,
adjusting bolt ¼ turn counter-clockwise.
If the Running Belt (No. C31) does not
move, repeat this step until it centers.
Refer to Figure A.
If the Running Belt
to the left, turn the left adjusting bolt ¼
turn clockwise, then turn the right
adjusting bolt ¼ turn counter-clockwise.
If the Running Belt (No. C31) does not
move, repeat this step until it centers.
Refer to Figure B.
Over time the Running Belt (No. C31)
will loosen. To tighten the Running
Belt (No. C31) turn the left & right
adjusting bolts one full turn clockwise,
check the tension of the Running Belt
(No. C31). Continue this process until
Running Belt (No. C31) is at the
correct tension. Make sure to adjust
both sides equally to ensure correct
belt alignment. Refer to Figure C.
MAINTENANCE & CARE
(No. C31) moves
then turn the left
(No. C31) moves
7