Maintenance And Care; Centering The Running Belt - Sunny Health & Fitness NIMBLE SF-T722072 User Manual

General cleaning will help prolong the life and performance of your treadmill. Keep the unit clean and
maintained by dusting the components on a regular basis. Clean both sides of the running belt to
prevent dust from accumulating underneath the belt. Keep your running shoes clean so that dirt from
your shoes does not wear out the Running Board (No. E21) and Running Belt (No. C07). Clean the
surface of the Running Belt (No. C07) with a clean damp cloth.
To better maintain the treadmill and prolong its life, it is suggested that the treadmill be powered off
for 10 minutes every 2 hours and fully powered off whenever not in use.

CENTERING THE RUNNING BELT:

Place the treadmill on level ground and set it at 2MPH to check if the Running Belt (No. C07) drifts
from the center.
If the Running Belt (No. C07) moves to
the right, turn the right adjusting bolt ¼ turn
clockwise, then turn the left adjustment bolt
¼ turn counter-clockwise. If the Running
Belt (No. C07) does not move, repeat this
step until it centers. Refer to Figure A.
If the Running Belt (No. C07) moves to the
left, turn the left adjusting bolt ¼ turn
clockwise, then turn the right adjustment bolt
¼ turn counter-clockwise. If the Running
Belt (No. C07) does not move, repeat this
step until it centers. Refer to Figure B.
Over time, the Running Belt (No. C07) will
loosen. To tighten the Running Belt (No.
C07), turn the left & right adjusting bolts
one full turn clockwise, check the tension of
the Running Belt (No. C07). Continue this
process until Running Belt (No. C07) is at
the correct tension. Make sure to adjust
both sides equally to ensure correct belt
alignment. Refer to diagram "C".
MAINTENANCE & CARE
12