Table of Contents
Advertisement
General cleaning will help prolong the life and performance of your treadmill. Keep the unit clean and
maintained by dusting the components on a regular basis. Clean both sides of the Running Belt (No.
20) to prevent dust from accumulating underneath. Keep your running shoes clean so that dirt from
your shoes does not wear out the Running Board (No. 70) and Running Belt (No. 20). Clean the
surface of the Running Belt (No. 20) with a clean, damp cloth.
To better maintain the treadmill and prolong its
for 10 minutes every 2 hours and fully powered off whenever not in use.
CENTERING THE RUNNING BELT:
Place the treadmill on level ground and set it at 3-5mph to check if the Running Belt (No. 20) drifts.
If the Running Belt (No. 20) moves to
the right, turn the adjusting bolt on the
right side ¼ turn clockwise, then turn
the left adjustment bolt ¼ turn counter-
clockwise. If the Running Belt (No.
20) does not move, repeat this step
until it centers. Refer to Figure A.
If the Running Belt (No. 20) moves to
the left, turn the adjusting bolts on the
left side ¼ turn clockwise, then turn the
right adjustment bolt ¼ turn counter-
clockwise. If the Running Belt (No.
20) does not move, repeat this step
until it centers. Refer to Figure B.
Over time the Running Belt (No. 20)
will loosen. To tighten the Running
Belt (No. 20) turn the Left & Right-
side adjustment bolts one full turn
clockwise, check the tension of the
Running Belt (No. 20). Continue this
process until Running Belt (No. 20)
is at the correct tension. Make sure to
adjust both sides equally to ensure
correct belt alignment. Refer to Figure
C.
MAINTENANCE & CARE
life,
it is suggested that the treadmill be powered off
10
Advertisement
Table of Contents
