Chapter 2 Install Your Product; Plug In Power; Connect Signal Source And Control Computer - RGBlink D8 User Manual

Chapter 2 Install Your Product

Note: D8 (HDMI 2.1)、D8 (DP 1.4) and D8 PLUS are same in installation. This chapter takes D8 (HDMI 2.1) as
example.

2.1 Plug in Power

Connect power and D8 with standard Power Cord. Plug one end of the power cable to the D8's power interface.
The other end is connected to the power socket.

2.2 Connect Signal Source and Control Computer

D8 supports HDMI 2.1、DP 1.4 input and HDMI 2.0 output. Connect D8 with Camera ,PC, laptop as input signal,
connect D8 with monitors, as shown in the figure below.
Before connecting signals to D8, ensure all the devices are all power off first, and then tighten connector
screws/locks where provided.
D8 supports XPOSE 2.0 control, so it is necessary to connect device with control computer.
Do direct connection via Serial Connection. Connect RS232 port of device and computer with serial cable.
© Xiamen RGBlink Science & Technology Co., Ltd.
Ph: +86 0592 5771197 | support@rgblink.com | www.rgblink.com
11