Table of Contents
Advertisement
Chapter 2 Install Your Product
2.1 Plug in Signals
Connect signals to the product (ensure all devices are powered off first). Tighten connector screws/locks where
provided.
2.2 Plug in Main Power
Connect IEC cable to device and plug into wall socket. Turn on power at wall socket.
2.3 Turn on Your Product
Turn the power switch on the rear to ON position.
TST screen shows as below，meanwhile the device enter initializing state after that，the device will load the
previously saved setting. On delivery, the default input is HDMI.
© Xiamen RGBlink Science & Technology Co., Ltd.
Ph: +86 0592 5771197 | support@rgblink.com | www.rgblink.com
INPUT HDMI：NO INPUT
SV: 2.00 SN：1043
OUTPUT FORMAT：1920×1080@60
12
Advertisement
Table of Contents
