Table of Contents
Advertisement
Chapter 2 Install Your Product
2.1 Plug in Signals
Connect signals to the input connector of device (ensure all devices are powered off first). Tighten
connector screws/locks where provided.
2.2 Plug in Main Power
Connect IEC cable to device and plug into wall socket. Turn on power at wall socket.
2.3 Turn on Your Product
After the device is boot up, the screen shows as below, meanwhile the screen will show its input and
output state and IP address.
Users can check input and output status by rotating the black knob, as shown in the figure below.
Note：
purple icon indicates input，
status as the example
Q16pro Gen2 1U
Input Status Interface
Output Status Interface
blue icon indicates output. Pictures above take HDMI input and output
User Manual
IP address
Input connector type
and resolution
IP address
Output connector type
and resolution
10
Advertisement
Table of Contents
Need help?
Do you have a question about the Q16pro Gen2 1U and is the answer not in the manual?
Questions and answers