Table of Contents
Advertisement
Display Area
When enter Layer Management interface, the window
is blank. The screen group created in Display System
shall be dragged from the Display Area.
Signal
Signal list, showing all input signals and resolutions
currently. Drag the signal to the display.
Click
, users can rename the input signal and then
click
to confirm.
Layer
Layer number：The number in the red rectangle on
the right figure represents the number of layers that
can be placed at the output.
As the signal is dragged in, the layer number
decreases. If the layer number has been used up, the
signal cannot be dragged in.
Note: D8 only supports 1*8K layer.
© Xiamen RGBlink Science & Technology Co., Ltd.
Ph: +86 0592 5771197 | support@rgblink.com | www.rgblink.com
41
Advertisement
Table of Contents
