Chapter 2 Install Your Product; Plug In Signals; Plug In Main Power; Turn On Your Product - RGBlink D8 User Manual

Chapter 2 Install Your Product

2.1 Plug in Signals

Connect signals to the product (ensure all the device are all power off first).Tighten connector screws/locks where
provided.
Connect RS232 port of device and computer with serial cable or connect LAN port of device and computer
with network cable or connect both device and computer to the same router, make sure their IP address is not
completely same.

2.2 Plug in Main Power

Connect IEC cable to device and plug into wall socket. Turn on power at wall socket.
If the devices is restarted, make sure the indicator light upon the PSU module is totally out before plugging
in the power.

2.3 Turn on Your Product

Turn on the power switch on the rear panel.
The system begins to work,and the TFT-LCD screen shows IP address, serial number and more.
© Xiamen RGBlink Science & Technology Co., Ltd.
Ph: +86 0592 5771197 | support@rgblink.com | www.rgblink.com
9