Emerson Rosemount FCL-01 Reference Manual page 2

Essential instructions
Read this page before proceeding!
Your instrument purchase from Emerson is one of the finest available for your particular application. Emerson
designs, manufactures, and tests its products to meet many national and international standards. Experience
indicates that its performance is directly related to the quality of the installation and knowledge of the user
in operating and maintaining the instrument. To ensure continued operation to the design specifications, read
this Manual thoroughly before proceeding with installation, commissioning, operation, and maintenance of this
instrument. If this equipment is used in a manner not specified by the manufacturer, the protection provided by
it against hazards may be impaired. Failure to follow the proper instructions may cause any one of the following
situations to occur: loss of life, personal injury, property damage, damage to this instrument, and warranty
invalidation.
• Ensure that you have received the correct model and options from your purchase order. Verify that this Manual
covers your model and options. If not, call 1-800-854-8257 or 949-757-8500 to request the correct Manual.
• For clarification of instructions, contact your Rosemount representative.
• Follow all warnings, cautions, and instructions marked on and supplied with the product.
• Use only qualified personnel to install, operate, program, and maintain the product.
• Install equipment as specified in the installation instructions of the appropriate Quick Start Guide and per
applicable local and national codes. Connect all products to the proper electrical and pressure sources.
• Use only factory documented components for repair. Tampering or unauthorized substitution of parts and
procedures can affect the performance and cause unsafe operation of your process.
WARNING
Electrical shock
Making cable connections to and servicing this instrument require access to shock hazard level voltages, which can
cause death or serious injury.
Equipment protected throughout by double insulation.
Disconnect main power and relay contacts wired to separate power sources before servicing.
Do not operate or energize instrument with case open.
Non-metallic cable strain reliefs do not provide grounding between conduit connections. Use grounding type
bushings and jumper wires.
Electrical installation must be in accordance with the National Electrical Code (ANSI/NFPA-70) and/or any other
national or local codes.
Unused cable conduit entries must be securely sealed by non-flammable closures to provide exposure integrity in
compliance with personal safety and environmental protection requirements. Unused conduit openings must be
sealed with NEMA 4X or IP65 conduit plugs to maintain the ingress protection rating (IP65).
Operate only with front and rear panels fastened and in place over terminal area.
Safety and performance require that this instrument be connected and properly grounded through a three-wire
power source.
WARNING
This product is not intended for use in the light industrial, residential, or commercial environments per the
instrument's certification to EN50081-2.
2