Main Display - Emerson Rosemount FCL-01 Reference Manual

Display and operation
October 2023
3. To hold outputs and relays associated with sensor 1, press ENTER/MENU. A check
4. To activate Hold, move the cursor to the APPLY at the bottom left of the screen and
3.5

Main display

3.5.1 Configuring the main display
The main display can be configured to meet your specific requirements.
Procedure
1. With the main display showing, press ENTER/MENU.
22
appears in the checkbox. To put sensor 2 on hold also, move the cursor to the
sensor 2 line and press ENTER/MENU to select the sensor 2 checkbox.
press ENTER/MENU.
The selected sensor outputs and alarm relays remain on hold until taken out of hold.
However, if power is lost and then restored, hold will automatically be turned off.
The screen describes how to take the transmitter out of hold.
Important
Be sure to press APPLY once the box has been unchecked.
A message stating which sensors are in hold appears in the fault/warning banner at
the bottom of the display.
The main menu appears.
Reference Manual
00809-0200-3412
Emerson.com