Table of Contents
Advertisement
Original power supply packs (e.g. TPS) or control units and connection cables are available for the elec-
tronic drive unit supply voltage.
Connection cable type
Connection cable with RS-485 interface and
bridges from TC 110|TC 120 to power supply
pack
Connection cable with RS-485 interface and ac-
cessory connectors from TC 110|TC 120 to
power supply pack
Connection cable with bridges from TC 110|
TC 120 to power supply pack
Connection cable with bridges and accessory
connectors from TC 110|TC 120 to power sup-
ply pack
Connecting electronic drive unit
1. Ensure the correct supply voltage.
2. Make sure that the power supply pack main switch is off prior to connection.
3. Use a suitable connection cable from the Pfeiffer Vacuum accessories range.
4. Plug the 15-pole connection cable plug into the "X3" connection on the electronic drive unit and
secure it.
5. Insert the connecting cable into the connection "DCout" on the power supply pack and close the
bayonet lock.
6. If you are using a Pfeiffer Vacuum control unit: Connect the "RS-485" connector to the control
unit using a suitable extension cable.
Function
● Voltage supply via power supply pack
● Automatic ramp-up with bridges on pins 2, 5, 7
● Connection to control unit via RS-485
● Voltage supply via power supply pack
● Connector for accessory units with M8 plug
● Connection to control unit via RS-485
● Voltage supply via power supply pack
● Automatic ramp-up with bridges on pins 2, 5, 7
● Voltage supply via power supply pack
● Automatic ramp-up with bridges on pins 2, 5, 7
● Connector for accessory units with M8 plug
Installation
29/54
Advertisement
Table of Contents
