Reconfiguring Your Storage System Disks - US Robotics USR8700 User Manual

To change this
The DNS server to use
The DHCP settings
The FTP settings
4. Click Apply.
5. When the confirmation message appears, click OK.
Note: If you changed the IP address of the storage system, you must now access the Web User
Interface using the new IP address.

Reconfiguring Your Storage System Disks

The Disks page displays information about all the hard disks that are currently installed in your storage
Do this
If your network includes a DNS server, and the storage system uses a specified
IP address rather than obtaining one from the DHCP server, enter the primary
IP address in the Preferred DNS server text boxes and the secondary IP
address in the Alternate DNS server text boxes.
If your network does not include a DNS server, or if the storage system obtains
its IP address from the DHCP server, leave these text boxes blank. (If thestor-
age system obtains its IP address from a DHCP server, the DNS server IP
address will be obtained from the DHCP server as well.)
If you want to use the storage system as a DHCP server, in the Port 1 group
box, select Use this IP address and enter the IP address and subnet mask in
the subsequent text boxes.
Then select the Enable DHCP server check box, enter the beginning IP
address in the Starting IP address text boxes, and enter the last IP address in
the Ending IP address text boxes.
For example, if the Starting IP address is 192.168.0.103 and the Ending IP
address is 192.168.0.107, the storage system will allocate the IP addresses
192.168.0.103, 192.168.0.104, 192.168.0.105, 192.168.0.106, and
192.168.0.107 to the first five computers that try to obtain their IP addresses
from the storage system. As soon as one of those computers shuts down or oth-
erwise loses its network connection, that IP address will be assigned to the next
computer that tries to obtain its IP address from the storage system.
If you do not want to use the storage system as a DHCP server, clear the Ena-
ble DHCP server check box. (If Get an IP address automatically is selected,
you cannot use the storage system as a DHCP server.)
If you want to use the storage system as an FTP server, select the Enable FTP
server check box.
If you do not want to use the storage system as an FTP server, clear this option.
For information about accessing the storage system using FTP, refer to
"Accessing the Storage System through FTP and Telnet"
Serial ATA 4-Drive NAS
User Guide
on page 75.
Managing Your Storage System - 66