Removing Protection - US Robotics USR8700 User Manual

To do this
Recover another disk or partition
Restart the computer
20. When the computer restarts, use the appropriate procedure for your system to configure the computer
to boot from the local hard disk once more.
21. Start DiskSafe Express and remove protection from the recovered disk or partition (as described in

"Removing Protection"

Since the computer is disconnected from the network, you might see messages about the backup
being offline. This is normal.
22. Restart the computer.
23. Protect the recovered disk once again (as described in
Removing Protection
If you no longer want to back up a particular disk or partition, you can remove protection as long as a
recovery is not currently in progress for that disk or partition. (If a recovery is in progress, you must cancel
it or wait until it completes before you can remove protection.)
Note: If you plan to delete a protected partition, be sure to remove protection before you delete that
partition. Otherwise, you might not be able to protect other partitions on that disk.
When you remove protection, you will no longer be able to back up the selected disk or partition either
automatically or manually, and you cannot recover data using DiskSafe Express (as described in
"Recovering Files from a Backup"
page 99). However, the backups that currently exist on the storage system are retained, and you can
recover them using the recovery CD (as described in
page 101).
If you subsequently want to protect the same disk or partition again, you can re-use the space that was
allocated for previous backups. You can also delete the existing backups on the storage system to free up
space for backups of other disks or partitions, either for this computer or other computers. For more
information, refer to "Deleting a Backup"
To remove protection:
1. In the Protected disk list on any page, select the disk for which you want to remove protection.
Do this
Select Continue.
If you want to recover a different backup of the same computer
from the same storage system, select Yes to retain the current
configuration settings and return to step 10.
If you want to recover a different computer's backup, or if you
want to recover a backup of the same computer from another stor-
age system, select No to modify the current configuration settings
and return to step 5.
Select Finish.
on page 104).
on page 97 and "Recovering a Non-system Disk or Partition"
on page 56.
"Protecting Your Disks"
"Recovering a System Disk or Partition"
Serial ATA 4-Drive NAS
User Guide
on page 86).
on
on
Protecting Local Disks - 104