Step Three: Install The Storage System Console - US Robotics USR8700 User Manual

Serial ATA 4-Drive NAS
User Guide
Powering Up the Storage System
To power up the storage system, insert the power cable into the power connector on the back of the
storage system and plug the other end into a power outlet.
Note: USRobotics recommends that you plug the storage system into a surge protector or
uninterruptible power supply to prevent damage to the system from power surges.
Once you have connected the power cable, make sure that the power switch on the back of the storage
system is set to the on position. Then press and release the power button on the front of the storage
system.
The power and Disk LEDs flash while the storage system is booting. Once the system has finished
booting, the Disk LEDs stop flashing.
If the hard disk installation was successful, the Disk LED is blue. If there is a problem, the Disk LED is off.
If this occurs, shut down the system, remove and inspect the hard disk for any installation problem, and
reinstall it. To shut down the system, press and hold the power button for approximately five seconds until
the Disk LEDs start flashing. Then release the power button; the storage system will shut down after a
short period.

Step Three: Install the Storage System Console

Install the Storage System Console on a computer on the same network as the Serial ATA 4-Drive NAS:
1. Insert the USRobotics Installation CD-ROM into your CD-ROM drive.
2. If prompted, select your preferred language, then review the License Agreement and click Yes.
The installation CD prompts you to make a choice:
3. Select Console Installation.
Getting Started - 16