Responding To Raid Failure; Swapping Hard Disks - US Robotics USR8700 User Manual

Responding to RAID Failure

When disk removal/failure causes the entire RAID to fail, the Disk Change Notification page appears
when you access the Web User Interface or refresh the browser window:
Take the appropriate action:
To do this
Scan the storage system again and
update the information on the page
Re-install the same disk
Reconfigure the storage system
using the available disks

Swapping Hard Disks

If you're using RAID 5 + spare or RAID 10, you can move the hard disks from one slot to another whether
Do this
Click Scan.
Click Shut Down.
After the storage system shuts down, re-install the same disk and then
restart the system.
Note: If you removed multiple disks, be sure to re-install them in the
opposite order than you removed them.
Click Reconfigure Disks and complete the system setup pages (as
described in "Step Five: Configure your Storage System"
Caution: Reconfiguring the storage system deletes all user information and
all data on all the disks.
Serial ATA 4-Drive NAS
User Guide
on page 20).
Disk Configurations - 113