Removing Protection - US Robotics USR8700 User Manual

The Restore dialog box appears.
13. Specify whether you are restoring to the original disk or a new disk.
If you are recovering to a new disk, select the desired disk from the list. Then click Restore.
14. When the confirmation message appears, click Yes.
The backup is recovered to your local disk, and the progress of this process is displayed. You can can-
cel the recovery at any time by clicking Stop in the progress dialog box.
Note: Do not shut down your computer, disconnect from the network, or perform any other tasks until
this process is complete.
15. After the recovery is complete, click OK to restart your computer.
16. Use the appropriate procedure to configure your computer to boot from the local disk once more.
17. If you changed the recovery password, reset it in the Microsoft iSCSI Initiator after your computer
restarts (as described in
page 145).
18. Start DiskSafe Express and remove protection from all your disks and partitions (as described in

"Removing Protection"

tect your disks again (as described in
ups.
If you need to recover any other data disks or partitions, you can do so (as described in
Non-system Disk or Partition"
tection and then reprotected the disks.
19. Enable remote boot again (as described in
Removing Protection
If you no longer need to back up a particular disk or partition, you can remove protection as long as a
"Resetting the Recovery Password in the Microsoft iSCSI Initiator"
on page 122). This disables remote boot and restarts your computer. Then pro-
"Protecting Your Disks"
on page 115). However, be sure to do this after you have removed pro-
"Enabling Remote Boot"
Serial ATA 4-Drive NAS
on page 98), reusing the existing back-
on page 110).
Protecting Local Disks - 122
User Guide
on
"Recovering a