Power Button/Fingerprint Reader Board - HP Spectre x360 Maintenance And Service Manual

2. Disconnect both cables from the ZIF connectors (2) on the touchpad.
3. Peel both cables (3) off the touchpad.
4. Remove the transparent screw covers (4) from the two screws near the middle of the touchpad.
5. Remove the larger piece of transparent protective tape (5) from the top screws.
6. Remove the 10 Phillips M1.6 × 2.0 screws (6) from the touchpad.
7. Lift the computer (1), and then remove the touchpad from under the computer (2).
To install the touchpad, reverse this procedure.

Power button/fingerprint reader board

To remove the power button board, use this procedure and illustration.
Table 5-13 Power button/fingerprint reader board description and part number
Description
Power button/fingerprint reader board, nightfall black
Power button/fingerprint reader board
Spare part number
N66410-001
61