Fingerprint Reader Board - HP ZBook 15 G4 Maintenance And Service Manual

Fingerprint reader board

Description
Fingerprint reader board (includes cable)
The fingerprint reader bracket is available in the Bracket Kit, spare part number 848232-001.
Before removing the fingerprint reader board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the solid-state drive (see
7. Remove the smart card reader (see
8. Remove the hard drive (see
9. Remove the WLAN module (see
Remove the fingerprint reader board:
1. Turn the top cover upside down with the front toward you.
2. Remove the Phillips PM2.0×2.0 screw (1) that secures the fingerprint reader board and bracket to the
top cover.
3. Lift the fingerprint reader board bracket off the fingerprint reader board (2).
The fingerprint reader board bracket is available in the Bracket Kit, spare part number 848232-001.
4. Detach the fingerprint reader board cable (3) from the system board.
Bottom cover on page
Battery on page 37).
Solid-state drive (M.2) on page
Smart card reader on page
Hard drive on page 46).
WLAN module on page
36).
40).
45).
41).
Component replacement procedures
Spare part number
850151-001
61