Table of Contents
Advertisement
Fingerprint reader board
Description
Fingerprint reader board (includes bracket and cable)
Before removing the fingerprint reader board, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the service cover (see
a.
Battery (see
b.
Hard drive (see
c.
Keyboard (see
d.
Top cover (see
Remove the fingerprint reader board:
1.
Turn the top cover upside down with the front toward you.
2.
Detach the fingerprint reader board cable (1) from the top cover. (The fingerprint reader board cable is
attached to the top cover with double-sided adhesive.)
3.
Remove the three Phillips PM2.0×2.5 screws that secure the fingerprint reader board and bracket to the
top cover.
4.
Remove the fingerprint reader board bracket (3).
Service cover on page
Battery on page
69)
Hard drive on page
71)
Keyboard on page
81)
Top cover on page
89)
67), and then remove the following components:
Component replacement procedures 115
Spare part number
730554-001
Advertisement
Table of Contents
