HP Spectre x360 Maintenance And Service Manual page 64

2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the large protective cover from the system board (see
page 47).
5. Remove the fans (see
6. Remove the heat sink (see
When you replace the system board, be sure to remove the following components (as applicable) from
the defective system board and install them on the replacement system board:
● WLAN module (see
● Solid-state drive (see
Remove the system board:
1. Disconnect the following cables from the system board:
NOTE:
● Large camera cable (1)
● Small camera cable (2)
● IR board cable (ZIF) (3)
● Audio board cable (ZIF) (4)
● Left speaker cable (5)
●
Large display cable (ZIF) (6)
●
Small display cable (ZIF) (7)
● Touchpad cable (ZIF) (8)
● Keyboard cable (ZIF) (9)
● Keyboard backlight cable (ZIF) (10)
● Touchpad cable (ZIF) (11)
● Right speaker cable (12)
● Power button cable (ZIF) (13)
● Antenna cables from WLAN module (14)
58 Chapter 5 Removal and replacement procedures for authorized service provider parts
Bottom cover on page
Battery on page
Fans on page
Heat sink on page
WLAN module on page
Solid-state drive on page
Some connectors are covered by transparent tape.
32).
34).
53).
54).
48).
50).
System board protective cover on