HP Spectre x360 Maintenance And Service Manual page 48

16 inch 2-in-1 laptop pc

Hide thumbs Also See for Spectre x360:

Table of Contents

When installing a camera module, position the rubber pieces with the arrows (1) pointing at

each other, and then place the rubber pieces (2) onto the module in the locations shown in the

following illustration.

To remove the touch board:

Disconnect the cables from the ZIF connectors (1) on the board, and then pry up to release the

board (2).

The touch board is available as spare part number N66383-001.

When installing a touch board, make sure tape installed at the locations as shown in the

following illustration.

To install the display components with the display attached to the computer, reverse these procedures.

Chapter 5 Removal and replacement procedures for authorized service provider parts

Table of Contents