Table of Contents
Advertisement
Power button board
Table 6-5
Power button board description and part number
Description
Power button board assembly
Power button board cable
Before removing the power button board, follow these steps:
1.
Prepare the computer for disassembly
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the power button board:
NOTE:
The power button board sits under the right display hinge. You do not have to remove the display to
remove the board, but you do have to rotate the right display hinge upward to gain access.
1.
Remove the two Phillips M2.5 × 4.0 screws (1) that secure the right display hinge, and then rotate the
hinge upward from on top of the power button board (2).
2.
Disconnect the cable from the ZIF connector on the power button board (3).
3.
Remove the Phillips M2.0 × 3.0 screw (4) that secures the power button board to the computer.
4.
Remove the power button board from the computer (5).
Reverse this procedure to install the power button board.
(Preparation for disassembly on page
Bottom cover on page
32).
32).
Battery on page
45).
Component replacement procedures
Spare part number
L60628-001
L60602-001 (Cable Kit)
51
Advertisement
Table of Contents
