VAT 651 Series Installation, Operating, & Maintenance Instructions page 29

Series 651
4.4.4.2 Sensor power wiring external
Low range sensor may be
connected to sensor 1 or
sensor 2 input. Do
configuration accordingly.
605451EC
INSTALLATION
•
Use shielded sensor cable(s). Keep cable as short as possible, but locate it away
from noise sources.
•
Connect Power supply (+24 / GND) at DB–9 male power connector and Sensors
(0V / + / -) at DB–15 female sensor connector exactly as shown in the drawing
above!
•
Connector: Use only screws with 4–40 UNC thread for fastening the connectors!
Edition 2014-07-10
Pins 4 and 8 must be
bridged for operation.
An optional switch
would allow for motor
interlock to prevent
valve from moving.
29/99