Electrical Information; Electrical Specifications; Wiring Requirements - kozy heat ROOSEVELT 29 BAK Installation And Operation Manual

Direct vent gas fireplace insert
Table of Contents

Advertisement

10.0 ELECTRICAL INFORMATION

WARNING: Do not use this fireplace if any part has been under water.
Immediately call a qualified service technician to inspect this appliance
and to replace any part of the control system and any gas control which
has been under water.
WARNING - Electrical Grounding Instructions: This appliance is
equipped with a three-prong (grounding) plug for your protection
against shock hazard and should be plugged directly into a properly
grounded three-prong receptacle. Do not cut or remove the grounding
prong from this plug.

10.1 Electrical Specifications

This appliance, when installed, must be electrically grounded in
accordance with local codes, or in the absence of local codes, with
Figure 10.1, Wiring Schematic
30
ELECTRICAL INFORMATION
the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical
Code, CSA C22.1.

10.2 Wiring Requirements

The IFC System Module requires 120V of electricity and/or
batteries to operate.
Using the battery back-up will operate the burner only.
Fan and light components will not function on battery back up
power.
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
#RVT-29-BAK R.3 November 2019

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rvt-29-bak

Table of Contents