Table of Contents
Advertisement
10.0 Electrical Information
WARNING: Do not use this fireplace if any part has been under
water. Immediately call a qualified service technician to inspect
this appliance and to replace any part of the control system and
any gas control which has been under water.
WARNING - Electrical Grounding Instructions: This appliance is
equipped with a three-prong (grounding) plug for your protec-
tion against shock hazard and should be plugged directly into a
properly grounded three-prong receptacle. Do not cut or
remove the grounding prong from this plug
10.1 Electrical Specifications
This appliance, when installed, must be electrically grounded in
accordance with local codes, or in the absence of local codes,
with the National Electrical Code, ANSI/NFPA 70, or the Canadian
Electrical Code, CSA C22.1.
(A)
120v Main Power Harness
(B)
Fan / Light Kit Harness
(C)
Ember Bed AUX Harness
(D)
On / Off Wire Harness
(E)
IFC Wire Harness
Figure 10.1 - Electrical Diagram
Hussong Mfg. Co, Inc.
NDK-48-DV - PFS Report No. 23-196
Part #700-350
Part #700-655
Part #800-AUX
Part #700-656
Part #700-653
10.2 Wiring Requirements
•
The system requires 120 VAC of electricity and/or batter-
ies to operate.
•
Using the battery backup will operate flame modulation
of the burner.
•
Fan and light components will not function on battery
back up power
Figure 10.1 - 10.3
Note: Spade connectors are labeled "M" for male connectors
and "F" for female connectors.
49
Starting Serial Number: 24 N48DV00001 04
Wire Color
Abbreviation
Blue
BL
Gray
GY
Black
BK
Brown
BR
Yellow
Y
Orange
O
Green
G
Red
R
White
W
Rev. 1 - November 2023
Advertisement
Table of Contents
