Figure 3-17: Lgw; Table 3-2: Lgw - Baicells Nova230i Installation Manual

Nova230i Outdoor 2x500 mW eNodeB Installation Guide
Field Name
Allow Management Access Over WAN Pane
Allow Management
Access Over WAN
LAN Config Tab
LAN Config Pane
IP Address
Subnet Mask
3.7.4.2 LGW
The LGW setting must be configured when using the Baicells CloudCore EPC. Refer to Figure 3-17
and Table 3-2. You must reboot the eNB when you make changes to these settings.

Figure 3-17: LGW

Table 3-2: LGW

Field Name
LGW
LGW Mode
LGW Interface Binding
Description
Used to enable/disable the Local Maintenance Terminal connection
through the WAN port (ON or OFF) for management purposes. If set to
ON, the administrator can maintain the eNB through the WAN interface.
The LAN interface IP address. The default value is 192.168.150.1.
Used to define the subnet mask address for the LAN interface. The
default value is 255.255.255.0.
Description
On or Off
Select an option:
NAT: Packages from the internal network to the external network need
Network Address Translation
Router: Select optimized route from the routing table (Figure 3-18)
Bridge: Transfer in the data link layer
The IP address connects to the LGW. Select from configured interfaces.
Default is WAN interface. The VLAN interface can also be used to separate
different links.
28