Table of Contents
Advertisement
Nova230i Outdoor 2x500 mW eNodeB Installation Guide
Table 3-1: WAN/LAN/VLAN
Field Name
WAN/LAN Config Tab
WAN Config Pane
Index
WAN Name
IP Access Mode
Option60
Netmask/Prefix
Gateway
IP Address
VLAN ID
DNS Config Pane
Index
DNS Address
MTU Config Pane
MTU
Description
The WAN index number, which is generated automatically. Four WAN
interfaces are the maximum number the eNB supports.
The WAN Name is generated automatically.
Used to select the desired interface protocol to be used by the WAN
interface:
• DHCP: only the Option60 parameter needs to be configured if DHCP is
the interface protocol selected.
• Static IP
• IPv6 DHCP
• IPv6 Static IP
Used to differentiate between different terminals when IP Access Mode
is set to DHCP. Range is 0–64 digits.
The IP address' subnet mask address. This parameter displays when
IP Access Mode is set to Static IP.
The IPv6 address' prefix for the WAN interface. This parameter displays
when IP Access Mode is set to IPv6 Static IP. Range is 0–128
The default gateway's IP address. This parameter displays when IP
Access Mode is set to Static IP.
The WAN interface's IP address. This parameter displays when IP Access
Mode is set to Static IP or IPv6 Static IP.
Used to configure more IP addresses for the WAN interface through the
VLAN when there is a need to transmit multi-types of data through a
separate channel. Range is 1–4094.
The DNS index number, which is generated automatically.
The IP address assigned to the DNS. Up to two DNSes are supported.
Used to specify the size of the largest network layer protocol data unit
that can be communicated in a single network transaction. Specifying
the correct MTU for the network can help to improve data transmission
efficiency.
Range is 700 to 1600 bytes. The default value is 1500 bytes.
27
Advertisement
Table of Contents
